TheLincolnForum.Net

some more pics

Trip from Karlsruhe Airport to Porto Airport.
On the Highway back via Portugal, Spain, France and Germany.

Hello,
the Job is done.
I´m back. New Color, good shape.
Drove back 2.000 km from Portugal to Germnay without any technical Problems.
Fuel Consumption 285 Liters. That makes About 14,4 Liters/100 km. Thats excelent.
Here are some pics from this road trip.

Yes, I did the conversion from York to sanden. I cannot tell you yet how it works. The car ist round about 2000km far abway from me. I tell you when I pick up the car I drive it back. Another pay told me that the conversion works great. The Compressor will work smoother and is much more better to se...

Most Jobs are done. There is an End in near future! Lots of works have been done. Lot of rust. I think the Color Change from White to dark blue metalic was a good Thing. The Mark III Looks very good in "X". In August I will pick up my Mark III in Portugal and I will drive him back to good ...

typical Problem zones

Body Works

Hi guys, in fact of the bad condition of my 71 Mark III I decided restore my Baby. In october 2017 I drove my Mark III from Germany to Portugal. Why Portugal? Because in Portugal the cost per hour are less than in Germany. In Portugal I can put four men to the price of one man in Germany. This is a ...

I use a 20 W 50 Oil. http://www.valvolineeurope.com/deutsch/products/engine_oils/vr1_racing/cid(11226)/vr1_racing_20w-50 I tested serveral Oil Types. The best oil for my 71 Mark III is this Valvoline 20W50 with a high ZZDP. Oil Consuption reduced to cero. Good oil pressure. Needs to be driven carefu...

To take a 12 V source for the pertronix for a Lincoln Mark III (1971) you can use the wire from the ignition Switch to jump the resistor wire. See Pictures.

Hello,

some ask my if my Name is really Frank Drebin:
No, it´s not.
My Name is Patric Frey.

Does a 1969 Ford Galaxie Steering Wheel fits to a 1971 Lincoln Mark III?

So folks,

I replaced the old 8 Track. This is thenew Retro Sound Zuma. You must cut the bezel from the backside al little. If you don´t do this, the original bezel will stay away about 3/4 cm.